The New Hitachi Summit range is highly economical and environmentally friendly, using the latest compressor and inverter technology keeping power consumption minimal, but at the same time providing you with powerful cooling and heating. High COP. DC Inverter driven compressors and fans. Enhanced inverter performance and system performance are achieved by the addition of a ‘Direct Current’ drive, resulting in up to 10% more efficient than standard 'AC' (Alternating Current) Systems. The variable speed compressor(inverter) enables the system to rapidly reach the desired room temperature setting. Once the desired room temperature has been achieved the compressor rotation speed is reduced, saving up to 30% in energy usage (when compared to standard fixed speed systems)
Product Key Feature's:
- High CoP, up to record 4.31
- Infra-red controller
- Slim construction 205mm
- Pipe runs up to 20 meters
- Low noise 44dBA on low
- Cold draft prevention on heat pump start up
- Fault diagnosis
- Auto re-start after power interruption
- PRE-CHARGED WITH REFRIGERANT for up to 20 metres pipe length
- Cleaner and healthier air with ion generator incorporated in indoor unit.
- Light weight noise absorbing outdoor unit
RAS Wall Mounted RAS-18FH6
Power source 1 ph 240V
Type Inverter rotary
COOLING (nominal) max. kW 2.0 / 6600 BTU
HEATING (nominal) max. kW 2.5 / 8250 BTU
UK Cooling (max) kW 2.5 / 8250 BTU
UK Heating (max) kW 3.2 / BTU 10600
Fuse Rating 16A
E.E.R. n/a
Energy label in heating A
Energy label in cooling A
C.o.P 4.31
ECA - Yes
Indoor Unit
Exterior dimensions (mm) 280 x 780 x 205
Net weight kg 9.5
Air flow rate* (cooling) (m3//min) 7.3/6.7/5.8
Air flow rate* (heating) (m3//min) 8.0/7.0/5.8
Outdoor Unit
Exterior dimensions (mm) 548 x 750 x 288
Net weight kg 35
Power Source Rating MCB A 15A
Refrigerant max piping length m 20
Pipe sizes - 1/4" x 3/8"
These air conditioning units must be installed by an F-Gas qualified engineer. We can install the unit for you using our F-Gas Certified Engineers. Please note if you do not select our installation service we will not ship the unit until we have obtained evidence from you that you will have the unit installed by an F-Gas qualified engineer. This is a requirement of the Article 11 (5) EC/517/2014 on fluorinated greenhouse gases and The Fluorinated Greenhouse Gases Regulations 2015.