Aspen MK4 Peristaltic Pump

Aspen MK4 Peristaltic Pump

Simply connect MK4 peristaltic pump to a permanent mains supply, fit the sensor to the air conditioner drip tray and connect to the drip tray using the vinyl tube supplied. The MK 4 Pump can be mounted remotely, as it is self-priming to a height of 3 metres (9.8ft), and will pump 6.25 litres (1.65 US gallons) of water per hour against a maximum head of 12 metres (40ft).

Unlike other pumps using either mechanical or electrical conductivity sensors, the MK 4 does not suffer from corrosion or contamination problems. When the lower sensor comes into contact with water, the heat conductivity from the sensor
provides a temperature difference setting the pump into motion.

The pump will only turn off when the water level has reduced below the lower sensor and any moisture on the sensor has evaporated. The mk 4 operates in dirty water.

 Products Key Features

• Operates on bead contact with water   
• Requires only 230V supply   
• Pumps water, fibrously contaminated
  water and air   
• Self-priming lifts 3 metres (9.8ft)   
• 12 metres (40ft) discharge head   
• No siphoning back   
• No loud sound from dry running   
• Fits into ceiling void or unit   
• Pump has a manual test switch   
• Water flow rate: 6.25 ltrs (1.65 US gallons)
  per hr @ 12 metres (40ft) head   
• Run on operation approx 5 mins   
• Pump rating: 0.2A, 230V
  Alternative voltages available
• Maximum water temperature: 40ºC   
• Fire retardant plastics